Introduction

Comet’s CTM-W series standard water temperature controllers combine efficiency & amp; high quality in a compact, portable design. High temperature water from the mold is returned to the cooling tank and cooled by direct cooling. This series is available in either 460 or 230 volt with a temperature range of 40° to 250°F and delivers temperature control with a +/-1°F accuracy. Primary features include direct injection cooling, non-ferrous piping, full diagnostics
and a non-proprietary controller. Units are available in 6, 9, 12, 24 and 36kW models.

Features

• Self-tuning microprocessor controller with a 3.2-inch LCD user-friendly interface.
• Direct injection cooling. Auto refilling device cools down the temperature to the set value.
• A high efficiency heat exchange of both molds and mold loops with small diameters.
• Full diagnostics with display and alarm buzzer protection against: loss of power, phase reversal, motor overload, high temperature, and loss of water pressure.interior of the pump is stainless steel to avoid combustion.
• Heavy duty powder-coated cabinet is both compact and portable.
• 7-day automatic start/stop timer, temperature converts between °F and °C. Time delay on pressure switch prevents nuisance trips.
• Safety features include: insulated, low watt density heaters, over temperature switch, fully enclosed air exhaust and primary fuse block, lockable cabinet, illuminated pump and heater on/off switches, Siemens finger-safe electricals, circuit protectors for both motor and heater, and audible alarm.
• RS485 communication interface achieves centralized monitoring with the host.

Options

• Magnetic filter to prolong the service life.
• Magnetic filter to prolong the service life of the magnetic pump (only suitable for models with a magnetic pump).
• Mold temperature and water mold return temperature display.
• Water removal using compressed air.
• Water manifolds and Teflon hose.
• Water flowmeter (248°F max. operating temperature).